Sega challenge F355, Руководство пользователя

Страница: 37 / 153

30 www.seuservice.com
9. HANDLE MECHA
Before starting to work, ensure that the Power SW is OFF. Failure to observe
this can cause electric shock or short circuit.
Use care so as not to damage wirings. Damaged wiring can cause electric
shock or short circuit.
Do not touch undesignated places. Touching places not designated can cause
electric shock or short circuit.
This work should be performed by the Location's Maintenance Man or
Serviceman. Performing work by non-technical personnel can cause electric
shock hazard.
Do not insert hand into the mechanism so as not to cause hand and fingers
pinched in. Failure to observe this can cause a serious injury such as a
fracture.
When performing work such as parts replacement other than those specified in
this manual, be sure to contact where you purchased the product from and
confirm the work procedures and obtain precautions prior to performing work.
Inappropriate parts replacement and/or installing with erroneous adjustment
can cause an overload or the parts to come into contact, resulting in an electric
shock, a short circuit, and a fire.
When adjusting the Volume, be sure to use 2 workers.
9 - 1 ADJUSTING OR REPLACING THE V.R.
In cases the Steering operability is poor and the adjustment of VOLUME SETTING in the
TEST mode is ineffective, the causes may be the Volume Gear's mesh failure and or Volume
malfunctioning. By using the following procedure, adjust Volume gear mesh, or replace the
Volume. In this product, when the Steering Wheel is moved fully left/right, if the Volume shaft
is rotating within the movable range, the Volume is not feared to be damaged. Secure the
Volume in the manner the Volume shaft is oriented as shown and the gears are appropriately
engaged when the steering wheel is in the centering position allowing the car to go straight
forward.
Be sure to use 2 workers in adjust-
ing the Volume, one is for operat-
ing the Steering Wheel and the
other one for performing the
adjustment.
Turn off power.
Take out 4 Truss screws to remove
the Rear Lid from the back of
Front Cabinet. At this time,
carefully support the Rear Lid as
taking out the 4 Truss screws can
cause the Rear Lid to drop.
REAR LID
TRUSS SCREW (4)
M4 X 16
PHOTO 9. 1 a
STOP
IMPORTANT!
ADJUSTING THE VOLUME
1
2