[Table of Contents]
[Previous Page]
[Next Page]
REPLACEMENT OF MOTOR BRUSH
On the output test screen in the test mode, when 1P gun or 2P gun display indicates ON, if the gun does
not vibrate, first check the switch unit's circuit protector. If the circuit protector is satisfactory, check the
motor brush.
By referring to the figures below, remove the cover left, cover right and the grip.
Remove a total of 6 U nuts to withdraw the slide mecha. Pay attention to the wirings to remove the
connector.
Take off the two screws from the lower part of the motor to remove the brush. If the motor brush is worn
away as shown, replace the motor brush. When replacing the brush, be sure to replace brushes for both
sides simultaneously.
Page 1 of 1
Motor Brush
7/12/2005
http://www.sauservice.com/manuals/Gunblade%20Folder/GB39.html
