Seenergy DOWN DRAFT, Инструкции и установка

Страница: 9 / 72

WARNINGS
EN/4
Electrical Connection

Before connecting the appliance to the electricity supply, check that the
voltage corresponds to that on the data plate and that the power supply
cable is suitable for the appliance load also stated on the data place.

If the appliance is connected directly to the mains, fit an all-pole
disconnect switch with minimum contact gap of 3 mm, adequate for the
appliance load and complying to regulations.
 The plug used must support the power of work of the appliance.
- Do not use reducers, adapters or switches for connection to the mains,
since these could overheat and cause burns
- Earth connection is required by law
If the power cable must be replaced, use a cable having identical
characteristics to the original supplied by the manufacturer, suitable for the
load and temperature. This is available from After-sales service.
Important!
The entire installation process is exclusively reserved for qualified
workers, installers or authorized technical service.
Before proceeding with the installation, make sure that all components are in
perfect conditions. Otherwise, contact the vendor and do not proceed with
the installation.
Once installed, the likely imperfections of the equipment such as scratches,
impacts, etc..., will not be covered by under warranty.
Maintenace
 Use only a damp doth with neutral liquid detergent.
 Do not use wet sponges or cloths, water jets, thinners, solvents, hydrochloric acid,
bleach, alcohol or abrasive substances.
 Unplug the appliance or switch off the circuit breaker before carrying out
maintenance operations.