Step 6 — Initial Setup
Check that your FSR's are working properly. You should see a blue light through the slots in the
side of the base with the power cord. Push down on the bed in a few different places and make
sure the lights flash/blink - you shouldn't need to push very hard. If they don't blink, contact
support.
Open a web browser and download the newest config files here:
https://github.com/seemecnc/Artemis
Open a new tab and enter the IP Address of your printer. When the page loads, click on "Settings"
in the lower left of the screen. Click on the "Upload Files" button, and upload the config.zip file that
you just downloaded.
Once it's uploaded, you will be prompted to reboot the Duet. Click yes. After about 10 seconds,
click the Refresh button on your browser and your printer will be running with the new config files.
Configuring Artemis
© 2018
seemecnc.dozuki.com/
Page 6 of 11
