WIRING DIAGRAM
REVERSE CAMERA
YELLOW RCA VIDEO CABLE
RED
WIRE
BLACK WIRE
Ground
Connect to +12V
Ignition
RED POWER PLUG
SV-9142.MDM
Monitor
MONITOR ADJUSTMENT:
1. Press and hold the Angle Adjustment button on the side of the monitor. The monitor will
flip down when the button is pressed. Release the button when you get the monitor to
the desired viewing angle.
2. Press and hold the button again until the monitor is in the closed position.
3. The monitor should now be set to your desired viewing angle and will lower to the set
position every time the reverse gear is engaged.
4. Turn the key to ignition to power monitor on. Make sure the camera is powered on so
that the monitor receives video signal and make sure the monitor lowers to your set
viewing angle. If not, then repeat from step 1. To change the viewing angle, repeat the
steps. (DO NOT force the monitor into the open position by hand. This may result in
damage to the mechanics inside the unit)
