INSTALLATION
MOUNTING:
OPTION 1: BRACKET MOUNTING
1. Find a suitable location on the trunk lip or license plate bezel to secure the mounting bracket
down to the body of the vehicle
2. Use the supplied 3M double-side tape to mount the bracket or you can also use screws to
secure it down. If using screws, make sure to double check behind the mounting surface.
3. Route the wire harness through the rear bumper of the vehicle or through any kind of rubber
grommet on the vehicle. If you have to drill a hole, make sure to seal the hole once you route
the wiring through to prevent leaking or moisture damage.
4. The flexible mounting bracket can be bent to give the driver the best viewing angle
OPTION 2: FLUSH MOUNTING
1. Twist the front camera lens cover counter clockwise to remove it. Once the cover is remove,
slide the red O-Ring and the metal lip mount bracket off of the camera and then slide the
supplied alternate metal flush mounting bracket and the O-ring back onto the camera.
2. Twist the alternate flush-mount camera lens cover clockwise onto the camera
3. Use the provided hole saw bit to drill the hole of the camera
4. Route the wire harness through the drilled hole and into the vehicle.
5. Snap the camera into place and adjust to give the correct viewing angle
SIDE
VIEW
Mounting
Surface
Cable
Mounting
Bracket
OPTION 1: LIP MOUNT
OPTION 2: FLUSH MOUNT
NOTE:
Use provided hole saw bit to drill the
hole for the camera to mount
Bracket
Screw
NOTE:
You can use either the double-side tape
or screws to mount the bracket
Camera Lens
3M
3M
3M
3M
3M
3M
DOUBLE SIDE TAPE
UNSCREW LENS COVER
REMOVE LENS COVER
REMOVE RED O-RING
REMOVE LIP MOUNT
BRACKET
ATTACH ALTERNATE
FLUSH MOUNT BRACKET &
REPLACE RED O-RING
ATTACH ALTERNATE
FLUSH MOUNT LENS
COVER
Mounting Clip
Camera
Lens
Cable
Mounting
Surface