A)
Press the number “8” on the phone to extend the time intervals for an additional 20 seconds to enter the listening
state. In the listening state the built-in microphone on the alarm host will be active to pick up any sound that takes place
near by the alarm host.
b)
Press the pound “#” button to replay the recorded voice message.
C)
Press the star “*” button, the host will end/drop the call and stop to dial the next enlisted alarm telephone numbers.
After the “*“ is pressed; the alarm host will resume to be armed.
note: The “*” is required in order to stop the alarm host from continuing to dial the next enlisted telephone numbers.
D)
Hang up the telephone without any command input, the host will end the call and automatically continues to dial the
next enlisted alarm telephone numbers.
remote arm by phone:
30 seconds after successfully dialing the telephone number of alarm host, there will be: a beep > enter
programming password of host > beep > enter 1 > beep, and the host will then automatically hang up after the last beep to
successfully complete the operation.
remote disarm by phone:
30 seconds after successfully dialing the telephone number of alarm host, there will be: a beep >
enter programming password of host > beep > enter 0 > beep, and the host will then automatically hang up after last beep to
successfully complete the operation.
Alarm dialing mode:
After the alarm host triggered or gone off, the alarm host will start to dial the first enlisted telephone
number, then the second, third, fourth and so on. Unless one of the enlisted telephone numbers answers otherwise this routine
auto dial will continue through a series of loop for three times.
Alarm priority:
If the telephone line is busy or in use when the alarm host is triggered, the alarm host will automatically cut off
the busy/used line and dial the enlisted telephone numbers to advise of the crime. The system will siren and then dial out to
the enlisted telephone numbers is the alarm’s top priority.
Telephone line disconnection Alarm:
If the telephone line is cut or comes off the hook, the host will beep every 5 seconds to
notify users that the telephone line is not connected to the TEL IN port of the alarm host unit or it is connected to the alarm
host but it is not an active telephone line. It will continue to beep until the phone line is fixed or reconnected.
“AWAY” Mode (Zone 1~15):
In this state, after any detection in the 1st, 2nd, or 24hr defense line is triggered, the alarm host will
immediately sound the sirens and at the same time automatically dial the enlisted telephone numbers in sequence.
“HOMe” Mode (Zone 1~10):
In this state, after any detection in the 1st or 24hr defense line is triggered, the alarm host will
immediately sound the sirens and at the same time automatically dial the enlisted telephone numbers in sequence. In HOME
mode, the 2nd defense line will be disabled and will not trigger the alarm host.
7
