ST-IP4VFB-MZ QUICK START GUIDE
12
12
● Make sure that there is no reflective surface too close to the
camera lens. The IR light from the camera may reflect back into
the lens causing poor image quality.
● The foam ring around the lens must be seated flush against the
inner surface of the bubble to isolate the lens from the IR LEDS.
Fasten the dome cover to camera body so that the foam ring
and the dome cover are attached seamlessly.
Steps:
1. Drill four screw holes in the wall according to the No.2 holes of
the supplied drill template.
Drill Template
Figure 2-1
2. Drill one cable hole according to the drill template.
If you want to route the cables through the side of the junction box,
you can skip this step.
Cable Hole
1
1
1
1
2
2
2
2
