ST-EZ16 QUICK START GUIDE
6
Thank you for purchasing our product. If there is any question or request, please do not hesitate to contact
dealer.
NVR Installation
During the installation of the NVR:
1.
Use brackets for rack mounting.
2.
Ensure there is ample room for audio and video cables.
3.
When routing cables, ensure that the bend radius of the cables are no less than five times than its diameter.
4.
Connect both the alarm and RS-485 cable.
5.
Allow at least 2cm (
≈0.75-inch) of space between racks mounted devices.
6.
Ensure the NVR is grounded.
7.
Environmental temperature should be within the range of , 14ºF ~ 131ºF.
8.
Environmental humidity should be within the range of 10% ~ 90%.
Hard Disk Installation
Before you start:
Disconnect the power from the NVR before installing a hard disk drive (HDD).
Surveillance grade
HDD
s
should be used for this installation.
Up to 2 SATA hard disks can be installed on your NVR.
Tools Required:
Screwdriver.
Steps:
1.
Remove the cover from the NVR by unfastening the screws on the rear and side panel.
2.
Connect one end of the data cable to the motherboard of NVR and the other end to the HDD.
3.
Connect the power cable to the HDD.
