Securiton ASD 535, Монтаж и установка, Страница: 27 / 40

Installation
ASD 535, Mounting and installation, T 140 333 d en 27 / 40
3.4 Installing expansion modules XLM 35, SLM 35, RIM 35, MCM 35, SIM 35
There are four expansion slots for equipping the detector housing with the optional expansion modules. Because of the mo-
dule-based assignment of the flat cable connectors on the AMB 35 Main Board we recommend the arrangement as shown in
Fig. 18 .
Each module set has a module holder, mounting screws and the connection cable (flat cable) for connecting to the AMB 35. A
Torx T15 screwdriver is used to tighten the mounting screws. The module can be removed from the holder for mounting in
the detector housing and for the subsequent electrical installation.
Fig. 18 Installing expansion modules
Notice
The expansion modules are automatically detected when the device is switched on, from which point they are
monitored and functional. The MCM 35 begins logging data as soon as the SD memory card is inserted (approx.
after 10 s; indicated by the flashing red LED on the MCM). To read out the SD memory card or when subse-
quently removing an expansion module (e.g. if not used), the expansion module must first be logged off via op-
eration on the AMB 35 Main Board (switch setting o ).
When installing modules other than XLM, SLM, RIM, MCM or SIM, the UMS 35 universal module holder is available. This is
fastened in the detector housing instead of the above described module holder and requires two expansion slots one above
the other (directly next to the AMB 35). The UMS 35 consists of an angled sheet metal plate with various fastening options for
expansion modules.
Notice, XLM 35 installation
With the installation of the use of an XLM 35, the ASD 535 meets the requirements in compliance with EN 54-17
(short-circuit isolation). To ensure that the required identification is recognisable in compliance with EN 54-17, the
supplied identification sign must be easily visible outside on the ASD housing and attached in the immediate
vicinity of the ASD rating plate (same side) when the XLM 35 is installed.
Option3
Option1 Option2
2 x RIM 35 on
cascaded
2 RIM 35
1 RIM 35
nd
st
Option3,
Mounting
screw
Module holder
Module
Flat cable
Module holder
Mounting
screw
XLM 35, SLM 35
(or SIM 35) on
Option1
MCM 35
(or SIM 35) on
Option2