2
STEP 3:
Charge your SecureStart™ by using wall adaptor immediately.
Make sure that the selector switch is in “OFF” position. Only at this position, the
SecureStart™ can be charged.
Plug the DC jack of the adaptor into the DC charging socket on SecureStart™.
Your SecureStart™ will begin charging upon switching on the wall adaptor.
Minimum 4 hours or permanently plugged-in charging. To maximize
SecureStart™ performance, permanent plugged-in charging is recommended.
On-Charge indication:
RED
:
FAST
Charging
GREEN
: SLOW Charging (ready)
IMPORTANT: The selector switch of the SecureStart
TM
must always be switched
to “OFF” position when it is not used for cranking.
When to Recharge Your SecureStart™
It is mandatory to recharge SecureStart™ immediately after used. SecureStart™ is
incorporated with smart charging system as to prevent overcharging. It is recommended
that the SecureStart™ be plugged in when not in used.
To determine whether the unit is ready to use simply press and hold the fuel-gauge switch to
observe the LED color on the indicator.
NOTE: The selector switch must be at “OFF” position.
Fuel gauge indication:
•
RED
: Immediately recharge your SecureStart™
•
GREEN
: Ready to jump-start
•
As fuel gauge traces the battery voltage, the indication may not be accurate right after the
unit is unplugged from the charging. Please check the fuel gauge after 30 minutes rest
from charging.
Recommended to plug in the wall adaptor when not in used.
It is recommended to store your SecureStart™ in a cool, dry location to maximize its
performance.
Failure to follow the charging instructions may shorten your unit’s service life.
For charging, plug the jack into the socket here
3
Jump-Starting Your Vehicle
IMPORTANT: Check the vehicle cranking system voltage first (12V or 24V)
before use.
1.
Turn vehicle ignition switch to OFF before accessing battery in vehicle or connecting cable
clamps to vehicle battery.
2.
Open hood of vehicle and position SecureStart™ away from fan blades, belts, pulleys or any
other moving parts.
3.
Make sure
that the selector switch of the SecureStart™ is at
‘OFF’
position.
4.
Connect
the
Red
positive (+) cable clamp
first
to the vehicle battery’s positive (+) terminal.
Rotate clamp slightly to ensure a good connection.
5.
Connect
the
Black
negative (-) cable clamp
last
to vehicle chassis, engine block, hanging
hook or other unpainted, non-moving metal surface that is away from the vehicle battery.
Rotate clamp slightly to ensure a good connection.
6.
Turn
the selector-switch on the
SecureStart™ to the vehicle
cranking system voltage
.
IMPORTANT: Turn to the wrong voltage will damage the vehicle electrical system
.
7.
Turn vehicle ignition switch and start the engine.
8.
If you intend to crank another engine immediately it is recommended to leave the cable
clamps of SecureStart™ connected for 3 minutes to allow a top up charge from the alternator
of the idling vehicle.
9.
Turn
the selector switch to
‘OFF’
position after used to prevent accidental short circuit of the
clamps and to allow recharge from the wall adaptor.
10.
Disconnect
the
Black
negative (-) cable clamp
first
and place it to its storage position in
your SecureStart™.
11. ONLY after removing and storing the Black negative (-) cable clamp,
disconnect
the
Red
positive (+) cable clamp
last
from the vehicle battery positive (+) terminal and place it to its
storage position in your SecureStart™.
12. It is mandatory to recharge your SecureStart™ immediately with wall adaptor for at least 4
hours.
Note: The SecureStart™ has successfully cranked on 12L diesel engine.
NOTE: Use SecureStart™ on gasoline-powered or diesel engines with a 12-volt or
24-volt cranking system. Read all instructions and safety warnings before use.
