Press button “1”. One beep will sound, indicating that the system is ready to receive the new
User Code
Enter a six digit code. Two beeps will sound.
Repeat the six digit code. One beep will sound, indicating that the six digit codes entered were
the same and the addition of the User Code was successful.
If 3 beeps sound, the programming attempt was unsuccessful. Repeat the steps above.
Notes:
If Three Beeps sound, the code change process has been unsuccessful and the existing code
is still valid. Repeat code change steps above.
Verify the new code at least 3 times to ensure the code has been programmed correctly
.
The system will revert to standby status if there is no key press within 10 seconds. Standby
status is indicated by two short beeps.
To Disable the User Code
Enter the Manager Code and hold down the last digit of this code. One beep will sound
indicating a valid code entry. Continue to hold down this digit until two additional beeps sound.
This indicates that the system is now in program mode.
Press button “2”. One beep will sound, indicating that the system has disabled the User Code.
To Enable the User Code
Enter the Manager Code and hold down the last digit of this code. One beep will sound
indicating a valid code entry. Continue to hold down this digit until two additional beeps sound.
This indicates that the system is now in program mode.
Press button “1”. One beep will sound, indicating that the system has enabled the User Code
To Delete the User Code
Enter the Manager Code and hold down the last digit of this code. One beep will sound
indicating a valid code entry. Continue to hold down this digit until two additional beeps sound.
This indicates that the system is now in program mode.
Press button “3”. One beep will sound, indicating that the system has deleted the existing User
Code
Now follow the “
To Add the User Code
“instruction if you wish to program a user
.
Default User Code
1 2 3 4 5 6
Default Manager Code
1 1 1 1 1 1
Your User Code
Your Manager code
