[01]
2
Wall Mounting
Wood stud
5.5mm
(7/32 in.)
13 mm
(1/2 in.)
2-1
Locate stud(s)
2-2
Mark the wall
Level the wall plate
[01]
and mark the hole locations.
2-3
Drill pilot holes
2-4
Tighten lag bolts
CAUTION:
Avoid potential injuries or property damage! Pilot
holes
MUST
be drilled to a depth of 75 mm (3 in.), using a 5.5 mm
(7/32 in.) diameter drill bit.
75 mm
(3 in.)
[01]
[04]
[05]
406 mm
(16 in.)
< 16 mm
(5/8 in.)
Verify the center of the stud(s) using an awl, a thin nail, or an edge to
edge stud fi nder.
CAUTION:
Avoid potential personal injuries and property damage!
!
Any material covering the wall must not exceed 16 mm (5/8 in.).
!
Minimum wood stud size: common 51 x 102 mm (2 x 4 in.) (nominal
38 x 89 mm (1.5 x 3.5 in.)).
O
R
O
R
O
R
O
R
CAUTION:
Avoid potential injuries or property damage!
Improper
use
could
reduce
the
holding
power
of
the
lag
bolt.
To
avoid
potential
injuries
or
property
damage
!
DO NOT
over-tighten the lag bolts
[04]
.
!
Tighten the lag bolts
[04]
only until the washers
[05]
are
pulled fi rmly against the wall plate
[01]
.
