9
4
3
3. Drill pilot holes using a 7/32 in. (5.5 mm) diameter drill bit.
IMPORTANT
: Pilot holes must be drilled to a depth of 2¾ in. (70 mm). Be sure to drill into the center of the studs.
4.
Install wall plate
10
using two lag bolts
11
and two washers
12
. Tighten the lag bolts only until the washers are pulled firmly against the wall plate.
CAUTION:
Improper use could reduce the holding power of the lag bolt.
DO NOT over-tighten the lag bolts
.
CAUTION:
Avoid potential personal injury or property damage! All lag bolts MUST BE firmly tightened to prevent unwanted movement of
the wall plate
10
. Ensure the wall plate is securely fastened to the wall before continuing on to the next step.
Go to STEP 3 on PAGE 12.
CAUTION:
DO NOT
use the lower slots for
installation, only use the upper slots as shown
7/32 in.
(5.5 mm)
2
¾
in. (70 mm)
10
11
12
UP
