2. Attach the antenna cable to the Wi-Fi module. Unscrew the antenna
from the brass fitting at the end of the cable, and insert the threaded
fitting up through the access hole in the control panel housing. Then,
screw the antenna down over the threaded part.
3. Move the jumper JP1 (located at the top of the control panel circuit
board) from pins 2 & 3 to 1 & 2 to enable the Wi-Fi module
4. Apply power to the control panel.
ACCESSINg ThE xPICO
®
WI-fI MODULE CONfIgURATION SCREEN
1. By default, the SoftAP mode is enabled with a default SSID of XpicoWiFi_
xxxxxx, where xxxxxx are the last six characters of the unique xPico
WI-Fi serial number (or the MAC address). For example if the serial
number is 0080A398010E then the SSID would be xPicoWiFi_98010E.
2. A Wi-Fi enabled device is required to configure the SK-WLSE-MOD.
You can use an Android or Apple (iOS) smart phone or tablet, or a
laptop computer. Disconnect any other networks from the device you
will be using to do the configuration.
3. On your mobile device, go to your Wi-Fi Settings, look for the SSID
named XpicoWiFi_xxxxxx, then select and connect your device to
it. The default security for the xPico WiFi SoftAP is WPA2 and the
passphrase is XPICOWIFI (case sensitive).
4. Open a web browser such as Google Chrome, Mozilla Firefox, Apple
Safari, or the latest version of Windows Internet Explorer (older
versions may not work) and navigate to either xpicowifi.lantronix.com or
192.168.0.1. If you do not see the xPico menu, try a different browser.
5. When prompted enter the USERNAME = admin and the PASSWORD =
PASSWORD to access the configuration and management web pages
(both are case sensitive)
6. Now you will be able to view the web configuration screen.
2
