Secure Vision, Secure Safety
Installation Manual:
ID-11 Controller
www.secursignal.com
IMPORTANT!
This manual provides all the necessary information for your SECUR product to be properly and safely
installed. Please read all instructions before installation, and make sure you follow them carefully during
the installation process. Failure to follow these instructions may result in DAMAGE to the product or
vehicle, and/or SERIOUS INJURY to you and your passengers!
NOTE: Do not install and/or operate this product unless you have read and understand all the safety information and instructions contained in this
manual.
Functions and Programming
Default: All buttons are default as NO/OFF Button
Programmable
Key: C1-C11
Momentary Switch Programming
Direc
�
on
Push C1 and C11 together for 5 seconds to enter Momentary Switch programming mode. L1 and R1 will
be steady on to indicate you are in programming mode for momentary switch.
-Hold the bu
�
on you desire to program for 3 Seconds to set as Momentary Switch. | The Red LED will
fl
ash 3
�
mes to indicate it has been set as momentary bo
�
om.
-Hold for another 3 seconds to reverse the se
�
ng. | The Red LED will
fl
ash once to indicate it has
been set as ON/OFF switch.
-Push C1 and C11 together for 5 seconds to exit programming mode.
Programmable
Key: C1-C11
Direc
�
on
Push C1 and C10 for 5 seconds to enter Express Key Programming Mode for C11. L3 and R3 will be
steady on to indicate you are now in programming mode for C11 express key.
-C11 Express key is design to quickly ac
�
vate a set of func
�
onality together at once.
-Once enter Express Key Programming Mode, press on the bu
�
ons that you wish to ac
�
vate together.
| The Red LED will light up to indicate the bu
�
on has been selected.
-Push C1 and C10 again for 5 seconds to exit the programming mode.
-By pressing C11, all the bu�ons you have previously set will now ac�vate together.
Express Key Programming
L1-5 / R1-5:
Flash Pa
�
ern Indicator
C1-C11:
Programmable bu
�
ons
C1:
Default set as an ON/OFF switch.
You may also hold the bu
�
on for
5 seconds to disable all func
�
ons.
|Hold the bu
�
on for 5 seconds to
resume all previous
func�ons.
Wiring:
-Each wire is design to connect to
one auxiliary func
�
on
-Input amps shall remain below
0.2Amps
-Please see the diagram on the
le
�
for wiring diagram for each
bu
�
on
