Seculink NVR1104PF, Инструкция по эксплуатации

Страница: 12 / 32

2. Format Storage
When you install the new hard disk,you should format storage first. Right-click“Main
Menu→System→General→Storage”. Choose the Hard Disk, click“Format Storage”. As
picture shows:
Select the hard disk you need to format
Left-click “Format Storage”
FAQ: NVR does not recognize the hard disk drive (HDD)
1. The video recorder does not support hot swapping when connected to the hard disk.
When the NVR is powered off, connect the hard disk and then power on to start the
recorder;
2. Check whether the hard disk is properly powered and whether the SATA data cable is
connected normally. You can replace the data cable to check whether the hard disk is
normally powered.
3. It may be the compatibility problem of the hard disk and the device, try to replace other
hard disks; it is recommended to use WD Purple Surveillance Drive.
4. Check if the power adapter used is the standard, it may be caused by insufficient power
of the power adapter. 1TB hard drive uses 2A power supply, 4TB needs to use 3A or larger
power supply.
5. It may be that the hard disk is damaged and cannot be used normally. Connect it to a
computer or other recorder equipment to test whether the hard disk is damaged.
6. Restore the default setting of the video recorder, and confirm that the firmware of the
NVR recorder has been updated to the latest version.
7. After the above steps are confirmed, it is still not recognized, you can contact Seculink
service team to process.