Seco SYS-B68-IGW, Инструкция по установке, использованию и предупреждениям

Страница: 16 / 19

SYS-B68-IGW
Information subject to change. Please visit
www.seco.com
to find the latest version of this manual.
Page.15 of 16
6.2 Installing the device
In order to install the device, make sure that the incoming electrical power supply complies with
the following values:
Power supply
Only use power supply that are certified according to
safety standards, pursuant to the regulations in force
in the country of use (EN 62368).
+ 18 V DC
MAX 5A
Minimum power required 40 W
To install the device properly on the destination machine , follow the procedure below:
1
Make sure the electric connection on the destination machine is off and the electric
power supply is disconnected from the device;
2
Proceed to fasten the device to the destination machine, using the relative screws
in points
(A) , indicated in the figure;
3
Proceed to connect the electric supply to the device. Once inserted, turn the
connector clockwise in order to lock it in place;
4
Proceed to electrically connect the destination machine.
For wallmount installation, follow the procedure below:
1
Make sure the electric connection on the destination machine is off and the electric
power supply is disconnected from the device;
2
Note: for wallmount configuration turn the device to keep the sink fins upright.
Proceed to fasten the device to the wall, using:
expantion screws
o
material: Nylon
o
type: SX5-SP 6X40mm
o
hole diameter: 6mm
o
hole depth: 40mm
screws
o
type: 4.5 x 60mm cylindrical head
plain washer