ENFORCER
®
High Intensity 1Wx4 Blue LED Module
4
SECO-LARM
®
U.S.A., Inc
Flash Patterns:
1.
LEDs are grouped into two sets, Set 1 and Set 2.
The left pair of LEDs are Set 1; right pair of LEDs are Set 2.
2.
To change patterns, momentarily connect the strobe’s yellow wire to +VDC:
Each connection to power will move to the next pattern.
Hint:
Use a programming switch (not included)—see
Wiring and Installation
on page 3.
1.
After changing, the flash pattern will first run one time, pause, then begin repeating.
2.
Internal memory will retain last setting when power is disconnected.
Pattern #
Flash pattern
Pattern #
Flash pattern
1
Single (2Hz)
4
Quad (2Hz)
2
Double (2Hz)
5
Randomly cycles all patterns
3
Triple (2Hz)
Alternates between Set 1 LEDs and Set 2 LEDs
6
Single flash each set
10
Rapid flash with fast alternation
7
Double flash each set
11
Ultra rapid flash with slow alternation
8
4x flash each set
12
Pattern 6 / Pattern 8
9
5x flash each set
13
Pattern 6 / Pattern 10
All LEDs light together
14
Single flash
18
Rapid flash
15
Double flash
19
Bursts of ultra rapid flash
16
4x flash
20
Pattern 14 / Pattern 16
17
5x flash
21
Pattern 14 / Pattern 18
Other
22
Set 1 steady ON; Set 2 double flash
23
All LEDs steady ON
California Proposition 65 Warning:
These products may contain chemicals which are known to the State of California
to cause cancer and birth defects or other reproductive harm. For more information, go to
www.P65Warnings.ca.gov
.
WARRANTY:
This SECO-LARM product is warranted against defects in material and workmanship while used in normal
service for a period of one (1) year from the date of sale to the original consumer customer. SECO-LARM’s obligation is
limited to the repair or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM.
This warranty is void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect,
repair, or alteration, improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines
that such equipment is not operating properly as a result of causes other than defects in material and workmanship.
The sole obligation of SECO-LARM, and the purchaser’s exclusive remedy, shall be limited to replacement or repair only,
at SECO-LARM’s option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential
personal or property damages of any kind to the purchaser or anyone else.
NOTICE:
The information and specifications printed in this manual are current at the time of publication. However, the
SECO-LARM policy is one of continual development and improvement. For this reason, SECO-LARM reserves the right
to change specifications without notice. SECO-LARM is also not responsible for misprints or typographical errors.
Copyright © 2021 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in whole
or in part, without the written permission of SECO-LARM.
SECO-LARM
®
U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606
Website: www.seco-larm.com
Tel: 800-662-0800 / 949-261-2999 Fax: 949-261-7326
E-mail: [email protected]
MI_SL-1311-MA-B_210630.docx
PITJW2
