ENFORCER 4-in-1 HD TVI, CVI, AHD, Analog Covert PIR Camera
SECO-LARM U.S.A., Inc.
3
Overview:
DC Jack
Important:
Do not cut any wires as the warranty will
be voided.
Female BNC connector
DC Plug with terminal block
Camera
pinhole
Mounting bracket
Slide camera
downward onto
the mounting
bracket
OSD Controller
Mounting bracket ball
Before starting:
1.
Use the camera within the given
temperature and voltage limits.
2.
Do not point the camera at the sun. Heat
can damage the camera even when not
in use.
3.
Do not subject the camera to strong
vibrations.
4.
Do not mount the camera in areas exposed
to radiation, strong magnetic fields, or strong
electrical signals.
Installation:
1.
Run a 12VDC power supply wire and a
video cable with a male BNC connector
through the wall to where the camera will
be mounted.
2.
Connect the camera’s video and power
cables.
3.
Temporarily mount the camera to test its
function and display.
4.
Do a preliminary test of the camera to
ensure it will work properly. Partially screw
a screw into the wall where the top of the
bracket should go. Slide the bracket onto
the screw. Finish securing the top of the
bracket to the wall.
5.
Secure the bottom of the bracket to the wall.
6.
Attach the mounting bracket ball to the
mounting bracket by gently pushing the ball
into the bracket.
7.
Attach the camera to the assembled bracket
by sliding the camera downward.
8.
Do a final test of the video camera and
monitor.
9.
Program the camera if needed via the
attached OSD joystick.
NOTE:
For the OSD manual, download from the
camera’s product page on www.seco-larm.com.
OSD Controller Settings:
To set format via the OSD controller, press
the controller in the direction of the desired
setting, hold for 5 seconds, and release
when the camera restarts.
See chart to the right.
Direction Format Setting
Up
CVBS
Down
CVI
Left
AHD
Right
TVI
C
am
er
a
Po
w
er
UP
DN
L
R
