ENFORCER Video Surge Protector
2
SECO-LARM U.S.A., Inc.
The ENFORCER Video Surge Protector is a passive device that helps prevent damage to sensitive
CCTV equipment from power surges or lighting strikes. The device can be deployed in new
installations or added to existing installations.
The ENFORCER Video Surge Protector should be installed between a camera and a digital video
recorder or video splitter to protect against surges that could damage video equipment.
NOTE: For the best protection, it is recommended that two video surge protectors be installed, one
near the camera, and one near the DVR.
Introduction:
Bandwidth
0~1GHz
Maximum input
1.0Vp-p
Insertion loss
<0.2dB
Return loss
16dB @ 75Ω
Frequency response
0-3dB at 10MHz
Isolation voltage
600VDC (min.)
Insulation resistance
10,000 MΩ
Maximum surge voltage
4KV
Surge life
300 surges @ 100A
Surge protection time
1ns
Surge resistance
Approx. 0Ω
Power passing capability
130 VAC/DC, 65 V
RMS
@ 10A
Connector
In
BNC Male
Out
BNC Female
Impedance
75 Ω (BNC-to-BNC)
Dimensions
3
1
/
16
” x 1” x 1” (78 x 25 x 25 mm)
Cable length
16” (406mm)
Weight
2.3-oz (65g)
Enclosure material
Aluminum
Operating temperature
32° ~ 131°F (0° ~ 55° C)
Specifications:
Installation:
1.
Detach the video cable BNC connector from the camera BNC connector.
2.
Attach the equipment end (male connector) of the first video surge protector to the camera BNC connector.
3.
Attach the video cable BNC connector to the cable end (female connector) of the first video
surge protector.
4.
Connect the ground wire from the first video surge protector to an earth ground.
5.
Detach the video cable BNC connector from the DVR/Multiplexor BNC connector.
6.
Attach the cable end (female connector) of the second video surge protector to the video cable
BNC connector.
7.
Attach the DVR/Multiplexor BNC connector to the equipment side (male connector) of the second video
surge protector.
8.
Connect the ground wire of the second VS-1V12BQ to the metal chassis of the protected equipment.
