Flexible operating voltage: 10~24 VAC, 9~48 VDC
Independently programmable channels
Compatible with all SECO-LARM HL-Series
transmitters of the same frequency
5 Output modes per channel
NOTE: Operating range will vary greatly depending on the installation and operating environment.
Installation Manual
917MHz HL-Series RF Receivers
The ENFORCER 917MHz HL-951 series RF transmitters and receivers use digital modulation for improved
immunity to interference, better signal penetration in environments with heavy obstructions, and significantly
longer range of up to 1,000ft (305m) line of sight. The transmitter's ultra-low power consumption gives you
longer battery life with easy to obtain coin-type batteries (CR-2032).
Mount the receiver out of sight in a location where it is not exposed to weather or moisture.
Installation Notes:
Introduction:
Compatible Transmitters:
HL-951R1-SQ shown
HL-951T1-SQ 1-Button pocket-sized pendant, 917MHz*,
CR-2032 coin-type battery
HL-951T2-SQ 2-Button pocket-sized pendant, 917MHz*,
CR-2032 coin-type battery
*
868.35MHz versions also available
Model
Channels
Output
Frequency* Operating Voltage
HL-951R1-SQ
1
1x 10A Form “C” relay output
917MHz 10~24 VAC, 9~48 VDC
HL-951R2-SQ
2
2x 10A Form “C” relay outputs
917MHz 10~24 VAC, 9~48 VDC
*
868.35MHz versions also available
®
®
1.
Press the selector button for 3 seconds or more. The channel’s LED will flash L1, indicating channel 1.
Press the selector to toggle between channels 1 and 2.
2.
After 2 seconds, the LED will slow flash with the display showing the number of codes already in storage
and enter programming mode.
NOTE: The LED will flash a maximum of 15 seconds. If the selector button or no transmitter button is
pressed during this time, the receiver will exit programming mode, and the LED will turn off.
Entering Programming Mode:
One- and Two-Channel Receivers:
HL-951T1-SQ shown
