ENFORCER Mini Vandal Dome Camera
SECO-LARM U.S.A., Inc.
3
SECO-LARM U.S.A., Inc.
33
3
1.
Please read this manual carefully and keep it
for future reference.
2.
Use the camera within given temperature and
electricity limits.
3.
Do not point the camera at the sun. Heat could
damage the camera, even when not in use.
4.
Do not mount the camera in areas exposed to
radiation, strong magnetic fields, or strong
electrical signals*
5.
Do not drop the camera or subject it to
strong vibrations.
Note:
Many video monitors produce strong
electromagnetic fields close to the display
CRT, especially when the monitor is turned
on or during de-gaussing, which occurs
automatically with many monitors when
turned on.
Before Starting:
1.
Run hidden cables from the video source and
12VDC power supply to the camera.
Do not
cut the DC jack or female BNC connector as
this will void the warranty. If needed, use the
included SECO-LARM DC plug with
terminal block.
2.
Test to make sure the voltage is correct.
Use only 12VDC.
3.
Undo the set screw on the side of the dome
cover using the included allen wrench and
remove the dome from the base.
4.
If mounting outdoors, apply the rubber seal to
the base as shown on page 2,
Applying the
Rubber Seal.
Installation:
5.
Hold the camera against the wall, ceiling, or
other mounting surface while watching the
monitor to find the best mounting location.
Mark that location with a pencil.
6.
Mount the mounting base to the wall using
the 3 included mounting screws. If
necessary, use the included screw anchors.
7.
Adjust the camera angle as needed.
8.
Test the video signal.
9.
Reattach the dome cover to the camera.
10.
Use the included allen wrench to tighten the
set screw, securing the dome to the base.
11.
Do a final test of the video camera and
monitor.
Overview:
Important:
Do not cut DC jack or female BNC connector
as warranty will be voided.
DC plug with
terminal block
Dome cover
DC jack
Mounting screw
Set screw
Female BNC connector
Camera
Mounting base
Wiring notch
