www.secabo.com
www.secabo.com
Online and Offline Mode
After switching on the machine, you will notice a Welcome screen for about
3 seconds with your current firmware version. The machine is reset and
switches into online mode. By pressing the button on the control panel,
you can switch between online and offline mode. During cutting the ma-
chine is always set to online mode. You can adjust downforce and cutting
speed while in online mode. For basic settings and setting the origin, the
machine must be switched into offline mode.
Setting the origin
While in offline mode, the arrow keys can be used to move the cutting
head and and the vinyl and .
The display shows the corresponding X and Y coordinnates. In order to set
the correct origin, move the cutting head to the lower right corner of the
vinyl. Then press the button to confirm the origin.
Pause
To pause a cutting job just press the button. The cutting job will conti-
nue when pressing the button again.
Adjust speed and downforce
While in online mode you can adjust the following settings
Increase speed
Decrease speed
Increase downforce
Decrease downforce
To change the cutting speed and the downforce during a cutting job, press
the button.
