5. Bag Full or Clog Warning
Auto Shut-Off. If the vacuum�s air flow pathway becomes restricted
due to a full bag or the existence of a clog, the red �BAG FULL OR
CLOG� light located on top of the power head will illuminate. If the
user ignores this warning for approximately 30 seconds, the
machine will shut off and the �BAG FULL OR CLOG� light will flash.
The user should turn the switch off, unplug the machine and
immediately insert a new bag or remove the clog (to remove a clog,
refer to the Clog Removal section on page 9). If the user restarts the machine without having solved the
problem, the �BAG FULL OR CLOG� light will again illuminate and the machine will shut off in 30
seconds.
Assembly
All illustrations shown in this manual represent the
G1 model except
where part numbers and instructions are different
for each model.
In those instances, illustrations for both the G1 and
G2 will be
shown.
Place the power head (9) on the floor with the swivel neck
(20) and the support lever (21) upright. Hold the dust
bag housing (6) vertically and place it over the swivel
neck and support lever. Push firmly and evenly down so
that the housing release button (8) snaps outward to its
�locked� position.
Slide the dusting brush clamp (25) onto the handle tube
(3) and tighten the screw. The handle of the dusting
brush (26) will now snap into the clamp.
To insert the handle tube (3) into the housing, lift the
catch (22), slide the handle in, making sure that the
handle is all the way in and cannot go any further. Push
the catch (22) down to lock handle in place. If the handle
is not pushed fully down, the vacuum will not work.
Push the black end of the attachment hose (12) into the connecting tube (24) so that it clicks into place.
Insert the attachment tube (15) into the swivel neck and push the handle (11) over the projection tab
(23).
Insert crevice nozzle (16) and upholstery nozzle (17) into the recesses in the back of the machine.
Return to Top
Operating Instructions
Starting The Machine - Figures 1 & 2
A. Before turning on your vacuum cleaner, make sure that the vacuum handle is in its upright locked
position and that you have a firm hold on the handle grip to keep the machine from moving forward.
1. Turn the quick release cable hook (14) to the up position by moving it to the left or right (figure 1).
2. Release the power cord plug from the power cord and lift the cord off of the upper cord hook (27 -
figure 2).
3. With the switch (2) in the �O� (OFF) position (figure 2), plug the polarized power cord into a 120
volt outlet located near the floor.
