Before st
a rting assembly
Before starting the assembly of your
Mytho S 30E
, remove each part from its bag and protection
for a prior inspection. Closely inspect the fuselage, wing panels, rudder, and stabilizer for damage. If
you find any damage or missing parts, contact the place of purchase.
If you find any wrinkles in the covering, use a heat gun or covering iron to remove them. Use
caution while working around areas where the covering material overlap to prevent separating the
covers.
Warranty information
SebArt garantees this kit to be free from defects in both material and workmanship at the date of
purchase.
This warranty does not cover any parts damage by use or modification, and in no case shall
SebArt’s liability exceed the original cost of the purchased kit.
Further, SebArt reserve the right to change or modify this warranty without notice.
In that SebArt has no control over the final assembly or material used for the final assembly, no
liability shall be assumed or accepted for any damage of the final user-assembled product. By the
act of using the product, the user accepts all resulting liability.
If the buyer is not prepared to accept the liability associated with the use of this product, the buyer
is advised to return this kit immediately in new and unused condition to the place of purchase.
Control throws
Please, follow the recommended linkage setups:
For the AILERONS we recommend the following throws:
High rate: 45° left & right
Normal flight: D/R:
30%
Expo:
20%
Snap: D/R:
100%
Expo:
90%
Spin & 3D: D/R:
100%
Expo:
90%
For the ELEVATOR we recommend the following throws:
High rate: 45° up & down
Normal flight: D/R:
30%
Expo:
30%
Snap: D/R:
40%
Expo:
50%
Spin & 3D: D/R:
100%
Expo:
95%
For the RUDDER we recommend the following throws:
High rate: 45° left & right
Normal flight: D/R:
40%
Expo:
60%
Snap: D/R:
50%
Expo:
70%
Spin & 3D: D/R:
100%
Expo:
90%
Note:
the
Expo
is (
+
) for JR systems, and (
–
) for Futaba systems.
