Required radio, motor and battery
•
6+ channel radio system
•
5 mini MG digital servos for ailerons, elevator, rudder and steering (A5060)
•
2 servo extension 500mm for elevator and rudder servos
•
2 servo extension 250mm for aileron servos
Additional required item, tools and adhesives
Tools:
•
Drill
•
Drill bits: 1,5mm
•
Phillips screwdriver
•
Hobby knife
•
Sanding paper
•
Masking tape
•
Soldering iron
Adhesives:
•
thin CA
•
medium CA
Warning
This RC aircraft is not a toy!
If misused, it can cause serious bodily harm and damage to property. Fly only in
open areas, preferably in official flying sites, following all instructions included
with your radio and motor.
Before starting assembly
Before starting the assembly, remove each part from its bag and protection for a prior
inspection. Closely inspect the fuselage, wing panels, rudder, and stabilizer for
damage. If you find any damage or missing parts, contact the place of purchase.
If you find any wrinkles in the covering, use a heat gun or covering iron to remove
them. Use caution while working around areas where the covering material overlap to
prevent separating the covers.
