SEB Krups EA8200, Руководство пользователя

Страница: 23 / 23

SEB INTERNATIONAL SERVICE
Avril 2014
23
6. ASS defect description
Defect Designation Priority Parts to be checked
1
Distributor position issue:
Time for distributor movment done and no
action from distributor.
1 Distributor
4
Priming issue:
Pump running=5sec & vol < 10ml
1 Claris filter
2 Flow meter
5
Flow metter defect:
Pump running and no flow
1 Flow meter
2 Pump
3 Pipes disconnected
6
Leakage in the water circuit during cylinder
decent:
Flow >50ml/min & vol measured>80ml
1 Distributor
2 Thermoblock
3 Pump valve
4 Hole on the pipe
7
Actuator obstruction defect:
Flow <50ml/min et vol measured <25ml
1 Claris Filter
2 Flow meter
8
Coffee circuit blocked:
After 5 secondes of disposal, flow <80ml/min
1 Thermoblock
2 Crimped pipe
3 Grinder (grinds are too fine)
9
CTN defect:
Temperature too high or too low regarding
the heating time
1 Thermoblock
2
Compaction head gasket
missing or defective
3 Fuse KO
12
Ejection issue (4 times defect 13) 1
Thermoblock
13
Cake ejection defect:
During cylinder upward, no ejection switch
impulse
1 Thermoblock
14
Calibration defect:
Lack of gauge or switch issue
1 No cake gauge
2 Cake heigh switch
15
Calibration defect with empty tank or on the
second coffee test:
Wrong flow meter impulse nbr or calibration
switch issue
1 Flow meter
2 Cake heigh switch
16
Calibration defect during measure of the
empty tank:
Value measured with empty tank is not
between 6 mm and 9.6 mm
1 Cake heigh switch
0A-10
Heating resistor issue:
The heating has been actuated and the
temperature has not change
1 Thermobloc
2 Fuse wires red and/or blue
0C-0D-
0E Comunication issues between Display and
power boards
1
Both boards are not
compatible