Application Note 0053
Rev 5:09.05.2017
Page 3 of 3
Pairing with the PrimeTest
300
/
350
Instruments
1)
Please charge your Bluetooth Scanner before you use it. This needs to be done via the USB port of a PC or a USB
adaptor –
it cannot be charged via the port of a Seaward instrument.
2)
Turn the PrimeTest on and select “Menu” -> “Configuration” -> “Bluetooth Favourites”.
3)
Highlight the “Barcode” field and press “Setup”.
4)
Scan the SPP barcode below using the Bluetooth scanner pressing the Trigger key (large button).
5)
Hold the Clear/Function key (small button) for 5 seconds until it beeps and starts to flash blue.
6)
It is now discoverable to your tester.
7)
Press “Search” to scan for local Bluetooth devices. (hint: it helps if the scanner is the only Bluetooth device turned
on at this time)
8)
Select the scanner in the “New” field (look for the device named “OPN2006_ . . . . . ”)
9)
Press “Add New”.
10)
Press “OK” to accept the new barcode setting, then press “OK” again to save the new Bluetooth configuration.
11)
You can now use the scanner to enter information such as asset IDs.
12)
If your scanner becomes disconnected from your tester you need to hold the Clear/Function key (small button) for 5
seconds to re-establish the connection.
(hint: if you press the Trigger key (large button) in an attempt to re-establish the connection this can put the
scanner into an incorrect mode. To reset this select Clear/Function key (small button) until the scanner
stops flashing and then again to re-establish the connection. (Note, if the above does not work may need to
switch your instrument off then back on again).
(Large button)
Connection On / Off Key
(small button)
Scan Trigger Key
(Large button)