Seaward 403A910, Руководство по эксплуатации

Страница: 26 / 43

PrimeTest 250+ Operating Instructions
25
•
Check that the appliance power switch is in the
ON position. The test will automatically proceed
if the appliance power switch is placed in the ON
position.
•
If the LO LOAd enunciator remains on the
display, the load presented by the appliance may
be too small for the PrimeTest 250+ to detect. In
this case, press the CLII test key to continue.
•
The PrimeTest 250+ will perform an Insulation
test. If the Insulation Resistance is greater than
the factory set limit a tick is placed next to the
Riso enunciator. If the Insulation Resistance is
less than the set limit a cross is placed next to
the
Riso enunciator, the FAIL enunciator is
displayed and the test sequence is halted.
Note : If a mains supply is detected, the
PrimeTest 250+ will perform a touch
leakage test.
If the PrimeTest 250+ does not detect a
mains supply then the PrimeTest 250+ will
perform a substitute leakage test.
•
If a Substitute Leakage test is performed then
the PrimeTest 250+ will start the test without the
need for user intervention. If the Substitute
Leakage is less than the factory set limit a tick is
placed next to the
I
EA
enunciator.