Seav RES 2175, Инструкции по подключению, Страница: 3 / 3

Supramatic S & GTS T.2 Start Contact T.3 Start Contact
T.3 24 Volt + T.1 24 Volt +
3 Terminals T.1 0 Volt (Common) T.4 0 Volt (Common)
HORMANN T.20 0 Volt (Common) T.2 0 Volt (Common)
Supramatic E & Promatic T.21 Start Contact T.3 Start Contact
GARADOR T.5 24 Volt + T.1 24 Volt +
Auto Expert & M2 T.20 0 Volt (Common) T.4 0 Volt (Common)
HORMANN T.1 0 Volt (Common) T.2 0 Volt (Common)
Ecostar T.1 0 Volt (Common) T.4 0 Volt (Common)
T.2 Start Contact T.3 Start Contact
T.3 24 Volt + T.1 24 Volt +
BOSCH T.3 - PCB 24 Volt + T.1 24 Volt +
Profilift T.4 - PCB 0 Volt (Common) T.2 0 Volt (Common)
T.5 outside Start Contact T.3 Start Contact
T.6 outside 0 Volt Common T.4 Common
T.3 and T.4 are where the black wires coming from the transformer to the PCB – 17 Volt A/C
SEIP T. G 24 Volt + T.1 24 Volt +
TS 75 and TS 100 T. H 0 Volt (Common) T.2 0 Volt (Common)
T. A Start Contact T.3 Start Contact
T. B 0 Volt Common T.4 Common
STANLEY Left hand T. 1 24 Volt + T.1 24 Volt +
3 terminals on back Right hand T. 3 0 Volt (Common) T.2 0 Volt (Common)
Centre T. 2 Start Contact T.3 Start Contact
Right hand T. 3 0 Volt Common T.4 Common
It would usually be recommended to remove any existing hard wired radio receivers before installing the new
Seav Radio Receiver
- ALWAYS ENSURE THE 24 Volt TERMINAL IS IDENTIFIED AND CONNECTED FIRST
– ENSURE ALL POWER IS ISOLATED AND TURNED OFF
Standard wiring instructions to suit most 3 terminal garage door operators not listed above:
Terminal 1, on electric operator – connect to Terminals 2 and 4 on the Seav Receiver
Terminal 2, on electric operator – connect to Terminal 3 on the Seav Receiver
Terminal 3, on electric operator – connect to Terminal 1 on the Seav Receiver
Alternative wiring instructions to suit some other garage door operators:
Terminal 1, on electric operator – connect to Terminal 1 on the Seav Receiver
Terminal 2, on electric operator – connect to Terminal 3 on the Seav Receiver
Terminal 3, on electric operator – connect to Terminals 2 and 4 on the Seav Receiver
DISCLAIMER: Every care has been taken to make sure the information contained within these wiring instructions is
accurate. However we cannot be held liable for any subsequent damage or failure following installation
Registered in England No 233 5784 V A T No 527 3897 10