Page 7
8.2
Preparing the units to be controlled
The monitors which will be controlled by the
PHT/SRT-CTL
need to be configured correctly. For
Seatronx
Monitors this can be
done by using the NCOM-Application software. For SCOM models you can set the unit number with the OSD-function.
Ncom and Scom can not be used simultaniously / mixed. The unit can be used in combination with VariCap illuminated
Capswitch system from
Seatronx
, both running on NCOM.
8.2.1
Setting units numbers for NCOM
The Monitor control page (see 9) has 12 dedicated buttons for monitors. Each button can be seen as a dimming source. These
source numbers are set in the NCOM app and correspond with the buttons shown in picture below:
Dimming control and non-dimming functions (power, source etc) are based on the unit ID with reference to the corresponding
Monitor control button. The easiest way is setting the Unit ID same as the monitor number in the chain.
1
2
3
4
5
6
7
8
9
10
11
12
Monitor control
page 1
Ncom
21-1
21-2
21-3
21-4
22-1
22-2
22-3
22-4
23-1
23-2
23-3
23-4
PHT/SRT-CTL
Monitor 1
Unit ID 1
21-1
Monitor 2
Unit ID 2
21-2
Monitor 3
Unit ID 3
21-3
Monitor 4
Unit ID 4
21-4
Monitor 5
Unit ID 5
22-1
Monitor 6
Unit ID 6
22-2
Monitor 7
Unit ID 7
22-3
Monitor 8
Unit ID 8
22-4
Monitor 9
Unit ID 9
23-1
Monitor 10
Unit ID 10
23-2
Monitor 11
Unit ID 11
23-3
Monitor 12
Unit ID 12
23-4
21, 22 and 23 are virtual Unit numbers
1-2-3-4 are virtual Sources. In the App the selected monitor
will be controlled by button [5]
