Seat Toledo 2019, Руководство пользователя, Страница: 123 / 300

Lights and visibility
 It lights up
Main beam on or flasher on
›››
page 122 .
 It lights up
Bulb failure
›››
page 86
For example, the information display indicates:
Check front right dipped headlight!
Several warning and control lamps light up
for a few seconds when the ignition is switch-
ed on, signalling that the function is being
verified. They will switch off after a few sec-
onds.
WARNING
Observe the safety warnings
›››
in Con-
trol and warning lamps on page 103 .
Note
The rear side lights and number plate light
contain several bulbs. The control lamp

lights up only when there is a fault in all the
number plate bulbs or side light bulbs (of a
combined tail light). Therefore it is advisa-
ble to regularly check the bulb operation.
Side light and dipped beam head-
light
Fig. 129
Instrument panel: light panel.
Switching the side lights on
–
Turn the light switch
›››
Fig. 129 to position

.
Switching on dipped beam
–
Turn the light switch
›››
Fig. 129 to position

.
Switching off lights (except daytime driv-
ing lights)
–
Turn the light switch
›››
Fig. 129 to position
0.
Headlight range control

Fig. 130
Instrument panel: light range control.
–
Turn the control
›››
Fig. 130 to set the lights
to the required setting.
Positions
The control positions roughly correspond to
the following vehicle load conditions.
Two front occupants, luggage compart-
ment empty.
All seats occupied, luggage compart-
ment empty.
All seats occupied, luggage compart-
ment fully loaded.
Driver only, luggage compartment fully
loaded.
CAUTION
Always adjust the range of the lights so
that:
»
-
1
2
3
121