Seat Leon 2013, Руководство по ремонту

Страница: 70 / 279

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
7 - Piston
❑ With combustion chamber.
❑ Mark installation position and cylinder number
⇒ page 64
❑ Removing and installing ⇒ page 65
❑ Checking pistons and cylinder bores ⇒ page 66
8 - Piston rings
❑ Compression rings
❑ Measuring piston ring gap
⇒ page 66
❑ Measuring clearance ⇒ page 67
❑ Use piston ring pliers (commercially available) to remove and install
❑ Installation position: marking “TOP” or side with lettering faces towards piston crown
❑ Offset gaps by 120°.
9 - Segment ring
❑ Oil scraping ring
❑ Measuring piston ring gap
⇒ page 66
❑ Measuring clearance ⇒ page 67
❑ use piston ring pliers for removing and installing
❑ Installation position: marking “TOP” or side with lettering faces towards piston crown
❑ Offset gap 120° from bottom compression ring
Installation position of pistons and allocation of piston/cylinder
• Arrow on piston crown points to pulley end -arrow-.
Installation position of bearing shell
– Insert bearing shells centrally in conrod and conrod bearing
cap.
• Dimension -a- = 2.5 mm
León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
64
Rep. gr.13 - Crankshaft group