Seat Leon 2005, Руководство пользователя, Страница: 242 / 277

If and when 241
Safety First Handling instructions Tips and Maintenance Technical Data
How to jump start
In
⇒
fig. 173 , the flat battery is A and the charged battery B .
Jump lead terminal connections
– Switch off the ignition on both vehicles
⇒
.
1. Connect one end of the red jump lead to the positive
⇒
fig. 173
terminal of the vehicle with the flat battery
⇒
2. Connect the other end of the red jump lead to the positive
terminal in the vehicle providing assistance
3. Connect one end of the black jump lead to the negative terminal
on the battery of the vehicle providing assistance
4. Connect the other end of the black jump lead to a solid metal
component which is bolted on to the engine block, or onto the
engine block itself of the vehicle with the flat battery. Do not
connect it to a point near the battery
⇒
5. Position the leads in such a way that they cannot come into
contact with any moving parts in the engine compartment
Starting
6. Start the engine of the vehicle with the boosting battery and let
it run at idling speed
7. Start the engine of the car with the flat battery and wait one or
two minutes until the engine is “running”
Removing the jump leads
8. Before you remove the jump leads, switch off the headlights (if
they are switched on)
9. Turn on the heater blower and rear window heater in the vehicle
with the flat battery. This helps minimise voltage peaks which are
generated when the leads are disconnected
10. When the engine is running, disconnect the leads in reverse
order to the details given above
Connect the battery clamps so they have good metal-to-metal contact with
the battery terminals.
If the engine fails to start, switch off the starter after about 10 seconds and
try again after about half a minute.
Fig. 173 How to connect
the jump leads
A
+
A
+
A
-
A
X
s1cg.2.book Seite 241 Montag, 25. April 2005 3:54 15