Instruments and warning/control lamps
exceeded (varies depending on the ver-
sion of the instrument panel), the memo-
ry is deleted.
Delete journey data presets
●
Select the memory that you wish to erase.
●
Hold the
button of the multifunction
steering wheel or the
button of the multi-
function wheel pressed down for about 2
seconds.
Select the instructions
In the Infotainment system, in the menu Vehi-
cle settings, you can display different travel
data
.
Current consumption:
The current
fuel consumption display operates
throughout the journey, in litres/100 km;
and with the engine running and the ve-
hicle stopped, in litres/hour.
Average consumption:
The average
fuel consumption is displayed after driv-
ing for approximately 300 metres.
Travelling time:
This indicates the
hours (h) and minutes (min) since the ig-
nition was switched on.
Range:
Approximate distance in km that
can still be travelled if the same driving
style is maintained.
–
–
–
–
AdBlue range or
:
Approximate
distance in km that can still be travelled
with the current level of the AdBlue®
tank with the same driving style. The in-
dication appears from a range of less
than 2,400 km and cannot be deactiva-
ted.
Distance:
Distance covered in km (m)
after switching on the ignition.
Average speed:
The average speed
will be shown after driving for approxi-
mately 100 metres.
Digital speed display:
Current
speed displayed in digital format.
Setting a speed warning
●
Select the display
Warning at ---
km/h
or
Speed warning at ---
mph
.
●
Press the button
on the windscreen
wiper lever or the button
on the multifunc-
tion steering wheel to store the current speed
and activate the warning.
●
Activate:
adjust to the desired speed within
5 seconds using the rocker switch
on the
windscreen wiper lever or by turning the
thumbwheel on the multifunction steering
wheel. Next, press the button
or
again or wait several seconds. The speed is
stored and the warning activated.
–
–
–
–
●
Deactivate:
press button
or button
. The stored speed is deleted.
The warning can be adjusted for speeds be-
tween 30 km/h (18 mph) and 250 km/h
(155 mph).
Display
Oil temperature
The engine reaches its operating tempera-
ture when, under normal driving conditions,
the oil temperature is between
80°C
(176°F)
and
120°C
(248°F). If a great effort is required
from the engine and the outside temperature
is high, the engine oil temperature may in-
crease. This does not present any problem as
long as the warning lamps
or
›››
do not appear on the display.
Warning and information messages
(Vehicle status)
The system runs a check on certain compo-
nents and functions when the ignition is
switched on and while the vehicle is moving.
Faults are displayed on the instrument cluster
display as red and yellow warning symbols
accompanied by messages and, depending
on the case, even an audible warning
»
1)
Not available in all countries.
77
Содержание Ateca 2020
