Seat Ateca 2018, Руководство пользователя

Страница: 102 / 412

Emergencies
Note
Due to the difficulty of accessing fog light
bulbs, have them replaced at a Technical
Service or specialised workshop.
Change the rear bulbs
Overview of tail lights
Tail lights on side panel
Turn signal PY21W NA LL
Side light and brake light P21W LL
Tail lights on the rear lid
Left side
Side lights P21W LL
Fog light/side light P21W LL
Reverse light W16W
Right side
Side lights 2x P21W LL
Reverse light W16W
The table corresponds to a right-hand traffic
vehicle. The position of lights may vary ac-
cording to the country.
Rear bulbs (in the side panel)
Fig. 114
Boot: access to the bolt securing the
tail light unit.
Fig. 115
Retaining tabs on reverse side of tail
light.
Follow the steps indicated:
Check which of the bulbs is defective.
Open the rear lid. 1.
2.
Remove the lid, levering it with the flat
side of a screwdriver into the recess
›››
Fig. 114
1
.
Remove the bulb connector.
Unscrew the light securing bolt by hand
or using a screwdriver
›››
Fig. 114
2
.
Remove the light from the body, gently
pulling it toward you, and place on a
clean, smooth surface.
Disassemble the bulb holder unlocking
the securing tabs
›››
Fig. 115
1
.
Change the damaged bulb.
To refit follow the steps in reverse order,
taking special care when fitting the bulb
holder. The securing tabs must click into
place.
CAUTION
Take care when removing the rear light unit
to make sure there is no damage to the
paintwork or any of its components.
Note
●
Make sure you have a soft cloth ready to
place under the glass on the rear light unit,
to avoid any scratches.
●
In the case of LED lights, change only the
turn signal bulb.
3.
4.
5.
6.
7.
8.
9.
100