INSTALLATION INSTRUCTIONS
Copy Par t# 764608, Rev. D, 09/2013
Page 2 of 2
© 2007 Marine Canada Acquisition Inc. DBA SEASTAR SOLUTIONS 3831 No. 6 Road, Richmond, B.C. Canada V6V 1P6
Fax: 604.270.7172
Web:
www.seastarsolutions.com
HELM FLANGE OUTLINE (for reference only)
4-5/8" (118mm) DIA. MAXIMUM COVERAGE
WARNING
Use self-locking type fasteners only; substituting non-self locking
fasteners can result in loosening or separation of equipment and
loss of steering control. DO NOT exceed 110 in-lbs. (12 Nm)
torque on helm and wedge nuts and bolts.
WARNING
DO NOT use Teflon Tape.
NOTICE
Por ts marked R are for the connec-
tion of additional steering stations
and/or an autopilot. Apply a Teflon
based, 'liquid' pipe sealant to the
threads going into the helm pump.
DO NOT
use Teflon tape.
Apply a liquid, Teflon based pipe sealant onto the threads going
into the helm pump.
• Tighten fitting
HAND-TIGHT.
• Using a wrench, tighten and additional 1.5 turns.
• Continue to tighten until desired orientation is achieved.
NPT Fitting Installations
