Sears CRAFTSMAN 944.602900, Руководство пользователя

Страница: 26 / 60

26
FIG. 35
SERVICE AND ADJUSTMENTS
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 34)
• Raise hood.
• Unsnap headlight wire connector.
• Stand in front of tractor. Grasp hood at sides, tilt toward
engine and lift off of tractor.
• To replace, reverse above procedure.
HOOD
HEADLIGHT
WIRE
CONNECTOR
FIG. 34
TO REPLACE HEADLIGHT BULB
• Raise hood.
• Pull bulb holder out of the hole in the backside of the
grill.
• Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill.
• Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
• Check wiring. See electrical wiring diagram in the
Repair Parts section of this manual.
TO REPLACE FUSE
Replace with 30 amp automotive-type plug-in fuse. The
fuse holder is located behind the dash.
IDLE FUEL
AD JUST ING
NEEDLE
IDLE SPEED
AD JUST ING
SCREW
STOP
SCREW
CLAMP
SCREW
CHOKE
CONTROL
CABLE
THROTTLE
CONTROL
CABLE
ENGINE
Maintenance, repair, or replacement of the emission con-
trol devices and systems, which are being done at the
cus tom ers expense, may be performed by any non-road
engine repair establishment or individual. Warranty repairs
must be performed by an authorized engine man u fac tur er's
service outlet.
TO ADJUST THROTTLE CONTROL CABLE
(See Fig. 35)
The throttle control has been preset at the factory and
adjustment should not be necessary. Check adjustment
as described below before loosening cable. If adjustment
is necessary, proceed as follows:
• With engine not running, move throttle control lever to
fast position.
• Check that speed control lever is against stop screw.
If it is not, loosen casing clamp screw and pull throttle
cable until lever is against screw. Tighten clamp screw
se cure ly.
FIG. 33
WEAK OR DEAD
BATTERY FULLY CHARGED
BATTERY