4
FIGURE 2B
CARTON CONTENTS
1. Sleeve Hitch Frame Assembly
2. Right Mounting Bracket
3. Left Mounting Bracket
4. Lifting Link Plate
5. Hitch Pin
6. Lift Lever Assembly (with Right Pivot Bracket)
7. Left Pivot Bracket
8. Sleeve Hitch Lift Assembly
ASSEMBLY
ORIGINAL NUT
LEFT MOUNTING
BRACKET
3/8" FLAT WASHER
(TOP HOLE ONLY)
REMOVE NUTS
FROM BOLTS
RIGHT MOUNTING
BRACKET
3/8" LOCK WASHER
(If new bolt and nut are needed)
FIGURE 1
1
3
4
5
6
2
7
8
TOOLS REQUIRED FOR ASSEMBLY
(1) 1/2" Wrench or Adjustable Wrench
(2) 9/16" Wrenches or Adjustable Wrenches
(1) 15/16" Wrenches or Adjustable Wrenches
• Assemble a 5/16" x 1" hex bolt, a spacer and a 5/16"
nylock nut to the three position slot in the Right Pivot
Bracket on the Lift Lever Assembly. Use the position
closest to the bend in the bracket (gives lowest
implement depth setting). See fi gure 1.
5/16" X 1"
HEX BOLT
5/16" NYLOCK
NUT
SPACER
PIVOT
BRACKET
FIGURE 2A
3/8" HEX NUT
3/8" LOCK WASHER
LEFT MOUNTING BRACKET
3/8" x 1-1/4"
HEX BOLT
RIGHT MOUNTING BRACKET
IF YOUR TRACTOR LOOKS LIKE FIGURE 2B
• Remove the nuts from the two bolts shown in each
side of the tractor, leaving the bolts in place.
• Attach the Left Mounting Bracket (pin at top facing
in) to the bolts using the original nuts and a 3/8" fl at
washer. Repeat for the other side.
NOTE: If no bolt and nut are present in a hole, use a
3/8" x 1-1/4" hex bolt, 3/8" lock washer and 3/8" hex nut to
attach the Mounting Bracket to the hole.
IF YOUR TRACTOR LOOKS LIKE FIGURE 2A
• Install two 3/8" x 1-1/4" hex bolts in the left side of the
tractor as shown. Attach the Left Mounting Bracket
(pin at top facing in) to the bolts using two 3/8" lock
washers and 3/8" hex nuts. Repeat on the right side.
