![Sears 795.75043 Series Скачать руководство пользователя страница 31](http://html1.mh-extra.com/html/sears/795-75043-series/795-75043-series_use-and-care-manual_1228682031.webp)
31
WATER FILTER
WATER FILTER
It is recommended that you replace the water
fi
lter:
Approximately every six months.
•
When the water
fi
lter indicator
•
turns on.
When the water dispenser output
•
decreases.
When the ice cubes are smaller
•
than normal.
Rotate the water
fi
lter up into
•
position and close the cover.
The cover will click when closed
correctly.
3.
After the water
fi
lter is replaced, dispense 2.5
gallons of water (
fl
ush for approximately 5 minutes)
to remove trapped air and contaminants from
the system. Do not dispense the entire 2.5 gallon
amount continuously. Depress and release the
dispenser pad for cycles of 30 seconds ON and 60
seconds OFF.
4. Water Filter Bypass Plug
Keep the water
fi
lter
bypass plug. You MUST
use the water
fi
lter
bypass plug when a
replacement water
fi
lter cartridge is not
available.
CAUTION:
DO NOT operate refrigerator without
water
fi
lter or water
fi
lter plug installed.
NOTE:
To purchase a replacement
fi
lter, visit your local
Sears store, or in the U.S.A. call 1-844-553-6667, and in
Canada 1-800-469-4663. You can also purchase online
at www.searspartsdirect.com.
Replacement Filter: 04609690000P
1. Remove the old water filter.
Lower or remove the top left shelf
•
to allow the water
fi
lter to rotate
all the way down.
Pinch the sides to open the
•
water
fi
lter cover.
NOTE:
Replacing the water
fi
lter
causes a small amount of water
(around 1 oz. or 25 cc) to drain. Place
a cup under the front end of the water
fi
lter cover to collect any leaking water.
Hold the water
fi
lter upright, once it is
removed, to prevent any remaining water
from spilling out of the water
fi
lter.
Pull the water
fi
lter downward
•
and pull out. Make sure to rotate
the
fi
lter down completely before
pulling it out of the manifold hole.
Before Replacing the Water Filter:
If the top shelf, located below the water
fi
lter, is in the
highest position, it will need to be removed prior to
replacing the water
fi
lter.
To remove any shelf–Tilt up the
front of the shelf
1
and lift it
2
.
Pull the shelf out.
2. Replace with a new water
fi
lter.
Take the new
•
water
fi
lter out
of its packing
and remove the
protective cover
from the o-rings.
With water
fi
lter tabs in the
horizontal position,
push the new
water
fi
lter into the
manifold hole until
it stops.
Water Filter
Bypass Plug