Sears 721.80402400, Руководство пользователя

Страница: 21 / 44

7-9
F. REMOVING DOOR (Figure 15)
(1) Remove the vent grille by two screws securing it to
the outcase loosening.
(2) Lift up and draw the door.
NOTES:
• After replacing the door, be sure to check that the
primary interlock switch, the secondary interlock
switch and the interlock monitor switch is in good
operating normally.
• After replacing the door, check for microwave
energy
leakage with a survey meter. Microwave energy
leakage must be below the limit of 5mW/cm
2 . (With a
275 ml water load)
G. DISASSEMBLING DOOR (Figure 16)
(1) Remove the dielectric choke by using knifeblade
or small screw driver, etc.
(2) Remove two screws securing it to the door handle.
CAUTION: Be careful not to damage door seal
plate with the screwdriver.
H. ASSEMBLING DOOR
(1) When mounting the door assembly to the oven
assembly, be sure to adjust the door assembly
parallel to the chassis. Also adjust so the door has no
play between the inner door surface and oven frame
assemblyIf the door assembly is not mounted
properly, microwaves may leak from the clearance
between the door and the oven.
I. REMOVING THE VENTILATION FAN ASS'Y
(1) Remove the mounting plate by removing two
screws securing it to the back plate.
(See Figure 17)
(2) Remove the two screws securing the MOUNT, ALL
and one screw securing the ventilation fan ASS'Y.
(See Figure 18-a)
Figure 15
Door Screen
Figure 16
Figure 17
Figure 18-a
Space
MOUNT, ALL