Seallence Winma-L100, Руководство по эксплуатации

Страница: 14 / 14

Seallence
6.
6. 6.
6. CALCU
CALCU CALCU
CALCULATIONS
LATIONS LATIONS
LATIONS
a. Maximum Winding speed for given wire diameter is
Speed = 1500 / wire diameter
Eg: wire diameter = 0.47mm, then
Speed = 1500 / 0.47
= 3191.5 rpm
b. Layer turns for given bobbin width and wire diameter is
Turns = bobbin width / wire diameter
Eg: wire diameter = 0.47mm, bobbin width = 50mm, then
Turns = 50 / 0.47
= 106.38 ~ 106 turns per layer
c. Maximum traverse start for given bobbin width is
Traverse position = traverse start + bobbin width
Eg: traverse start =
Traverse position = 15 + 80 = 95mm < 99.9
7. 7. 7. 7. SAFTY INSTRUCTIONS SAFTY INSTRUCTIONS SAFTY INSTRUCTIONS SAFTY INSTRUCTIONS
Do not put any material inside the slots of machine top plate.
Make sure the mandrill is tight, before winding.
Do not touch the mandrill or bobbin while the spindle is rotating.
Do not push or pull the traverse unit when the machine in ON.
Try to avoid the stop function when the spindle is rotating at higher speeds
decelerate the spindle before stopping, i.e. at the end of winding spindle has to stop
after coming to lowest speed. To
(deceleration time) and 10
winding turns and speed.
For more details contact
Email- seallenceproducts@gmail.com
Seallence, Bengaluru
Working
Maximum Winding speed for given wire diameter is
Speed = 1500 / wire diameter
g: wire diameter = 0.47mm, then
Speed = 1500 / 0.47
= 3191.5 rpm
Layer turns for given bobbin width and wire diameter is
Turns = bobbin width / wire diameter
g: wire diameter = 0.47mm, bobbin width = 50mm, then
8 ~ 106 turns per layer
Maximum traverse start for given bobbin width is
Traverse position = traverse start + bobbin width <= 99.9mm
Eg: traverse start = 15mm, bobbin width = 80mm
Traverse position = 15 + 80 = 95mm < 99.9
SAFTY INSTRUCTIONS SAFTY INSTRUCTIONS SAFTY INSTRUCTIONS SAFTY INSTRUCTIONS
any material inside the slots of machine top plate.
Make sure the mandrill is tight, before winding.
Do not touch the mandrill or bobbin while the spindle is rotating.
h or pull the traverse unit when the machine in ON.
Try to avoid the stop function when the spindle is rotating at higher speeds
decelerate the spindle before stopping, i.e. at the end of winding spindle has to stop
after coming to lowest speed. To achieve this, adjust the 2
nd
(deceleration turn), 9
(deceleration time) and 10
th
(brake point) parameter properly according to the
winding turns and speed.
For more details contact: 9964477934/9538594642/9844667565
seallenceproducts@gmail.com
Working Manual
Page 14
Try to avoid the stop function when the spindle is rotating at higher speeds. Always
decelerate the spindle before stopping, i.e. at the end of winding spindle has to stop
(deceleration turn), 9
th
(brake point) parameter properly according to the