Latest products and information available at www.sealite.com
13
SL-125 Series 5-9NM+ LED Marine Lantern
Settings of SL-125 & SL-125-C Models
Before installing the light, intensity and flash settings must be set.
1. Remove the bolt/lock securing the battery box lid, and open unit (SL-125-C ONLY).
2. Remove the bung from the base of the SL-125 light.
3. The power and range settings of the lantern are adjusted by setting the DIP switches inside the
lantern. Your lantern is normally set to maximum range (see ‘Selecting Intensity/Power Setting’
section of this manual).
4. Set rotary switches to the required flash code (see ‘Selecting a Flash Code’ section of this
manual).
5. Replace bung.
6. A sealed vent on the base allows air transfer without moisture intake, and should not be disturbed.
Note:
Lantern is activated by connecting positive and negative battery wires (and solar module
wires for SL-125-C).
Activation and Installation of SL-125
1. Battery Connection: Connect “Battery Positive (+)” wire to positive terminal of battery, and “Battery
Negative (-)” wire to negative terminal of battery.
Mains Connection: Connect positive and negative wires to 12volt power supply (ONLY).
2. To test place dark cover (towel or jacket) on top of light to activate sensor, light will come on within
one minute.
3. Ensure that the unit is bolted to an even, flat surface
.
Activation and Installation of SL-125-C
1. Inside the battery box is an internal battery container. To access the battery, remove the four
screws and lid of this internal container.
2. Connect the “Battery Negative (-)” wire to the negative terminal of the battery, and the “Battery
Positive (+)” wire to the positive terminal of the battery.
3. Connect the “Battery Positive (+)” and “Battery Negative (-)” wires from the Solar Regulator to the
battery.
4. Replace the internal battery container lid and screws making sure no wires are protruding.
5. Close the battery box lid and secure with bolt/lock. Light is now activated.
6. To test place dark cover (towel or jacket) on top of light to activate sensor, light will come on within
one minute.
7. Ensure that the unit is bolted to an even, flat surface.
Care must be taken to observe the polarity of each wire before they are connected.
Note:
Refer to ‘Lantern Status’ section of this manual to check the status of the light after
activated. Indicated by red and yellow status LED’s viewed at the base of the lens.
Installation
