Latest products and information available at www.sealite.com
9
BargeSafe™ 3NM LED Barge Light
UL 1104 Certified & COLREG-72
Problem
Remedy
Lantern will not activate
• Ensure lantern is in darkness.
• Wait at least 60 seconds for the program to initialise in darkness.
• Ensure battery is properly connected.
• Ensure battery has sufficient voltage.
• Check the Status LED in the light sensor port. If it is flashing the
battery charge is insufficient to power the light.
Lantern will not operate for the
entire night
• Battery needs either recharging or replacement.
Battery is corroding due to water in
the compartment
• Check the rubber seal is fitted correctly. Make sure there are no
cracks or holes in the seal. Make sure a silicon grease is used on
the seal for added sealing.
• Check the polycarbonate case for cracks or holes.
Lantern will not turn off
• Ensure the light sensor is not covered with debris.
Light is flashing, not steady on
• Battery charge is low, (below 3.7V) please change battery to
ensure safe operation. When the light senses a low battery it will
flash for 0.5 seconds every 10 seconds.
