6.1.2.
Position the V blocks or press tools to be used onto the table and align beneath the ram. Place workpiece onto the table or V blocks
and align beneath the ram as required.
Note:
Care must be taken to ensure a V block does not fall from the press table.
If necessary hold the configuration in position with clamps (not supplied).
6.1.3.
Operate the pump slowly until the ram is close to or just touching the workpiece. Before applying real pressure to the workpiece
recheck the alignment with the ram and ensure that the workpiece and press tools are supported in such a way that they cannot flex to
breaking point.
DO NOT
exceed the stroke indicated on the label or the red mark on the piston and
DO NOT
apply off centre loads.
6.1.4.
When work is complete release the pressure by fitting the handle over the release valve and turning anti-clockwise in small increments.
6.1.5.
Once the hydraulic unit has been fully retracted, remove the workpiece from the V blocks and the table.
Note:
Always keep the piston retracted after use to avoid corrosion.
7. MAINTENANCE
Note:
Maintenance and repair must only be carried out by qualified person. Contact your Sealey stockist for details.
7.1.
When the press is not in use, the hydraulic unit ram must be fully retracted to minimise corrosion. Remove the handle to inactivate the
press.
7.2.
Lubricate all moving parts at regular intervals.
7.3.
Always keep the press clean, dry, and protected from harsh conditions.
7.4.
Should you need to replace the oil, ensure the hydraulic unit ram is fully retracted. An excess of oil will render the press inoperative.
Use only appropriate Sealey hydraulic jack oil (Sealey Part Number: HJO500MLS/HJO5LS).
DO NOT
use brake fluid.
Purge the system to remove any air.
7.5.
Check your model parts information for spares.
IMPORTANT:
NO RESPONSIBILITY IS ACCEPTED FOR INCORRECT USE OF THE MACHINE.
Hydraulic products are only repaired by local service agents. We have service/repair agents in all parts of the UK.
DO NOT RETURN PRODUCT TO US.
Please telephone us on 01284 757500 to obtain the address and phone number of your local
agent.
If product is under guarantee please contact your dealer.
De-commissioning Product
Should the product become completely unserviceable and require disposal, draw off the oil into an approved container and dispose of
the product and the oil according to local regulations.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
01284 703534
www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
YK20ECF.V2 Issue 1 19/03/21
Original Language Version
© Jack Sealey Limited
Note
: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice. Please note that other versions of this product are available. If you require documentation for alternative versions, please email or call our
technical team on [email protected] or 01284 757505.
Important
: No Liability is accepted for incorrect use of this product.
Warranty
: Guarantee is 12 months from purchase date, proof of which is required for any claim.
