a.
Motor operates but
there is no suction.
b.
Reduced water
volume for level
of water
c.
The pump will not start
or suddenly stops
during operation.
1.
No electrical power.
2.
Float not working.
1.
Check cable, plug and fuse.
2.
Contact authorised service agent.
1.
Discharge pipe too narrow.
1.
Use wider diameter pipe.
1.
Water level below min suction depth.
2.
Air bubbles in pump accumulated during submersion,
or float is incorrectly positioned so pump does not stop
at minimum level and sucks in air.
3.
Clogged intake or discharge pipe.
1.
Stop the pump.
2.
Release air by inclining the pump and
re-immersing it in water.
3.
Remove blockage, and clean the unit.
TROUBLESHOOTING
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT:
No liability is accepted for incorrect use of this product.
WARRANTY:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION:
For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park
,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Web
Parts support is available for these products. To obtain a parts listing and/or diagram, please log on to
www.sealey.co.uk, email [email protected] or phone 01284 757500.
Environmental Protection.
Recycle unwanted materials instead of disposing of them as waste.
All tools, accessories and packaging should be sorted, taken to a recycle centre
and disposed of in a manner which is compatible with the environment.
NOTE:
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of
experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible
for their safety. Children should be supervised to ensure that they do not play with the appliance.
Original Language Version
WPl117A Issue: 1 - 28/11/13
© Jack Sealey Limited
WEEE Regulations.
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic
Equipment.
When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
4. MAINTENANCE
WARNING! With the exceptions listed below, all pump, float and electrical cable service maintenance and repair must only be
undertaken by an authorised service agent. Failure to observe this rule may be dangerous and will invalidate the warranty.
WARNING! Ensure the pump is disconnected from the mains power supply before attempting any service or maintenance.
4.1.
Keep all parts of the pump clean. Rinse, drain and allow to dry before storing the pump.
3.5.
USING AS A PUDDLE PUMP:
In order to draw water from a shallow depth, the float switch needs to be immobiled as in fig.3. In this
mode the pump will not function automatically so, consequently, must be not be left unattended owing to the risk of overheating. The
normal medium for cooling the pump motor is the water in which it is submerged, therefore excessive use in the open air carries the
risk of damage.
fig.3
