4. STORAGE
4.1.
If there is a risk of frost, dismantle the pump and accessories, clean and store them in a place protected from frost.
5. TROUBLESHOOTING
Fault
Cause
Solution
Pump does not run.
No mains voltage?
Check cables, plug, socket and fuse.
Motor overheats due to:
- liquid temperature too high
- pump blocked by foreign bodies
Eliminate the cause of the overheating of the liquid (max.
temperature of liquid able to be pumped is 35°C.
R
esidual current circuit breaker (RCCB)
triggered.
A
ctivate RCCB.
C
ontact qualified electrician if RCCB triggers again.
Motor defective.
Contact Sealey service.
Pump runs but does not
pump.
Suction openings blocked.
Rectify blockage.
Pump draws in air.
Keep the pump at an angle while submerging.
Switch the pump on and off several times in order to expel
air.
Pump blocked by foreign bodies.
Clean the pump suction area.
Delivery rate low
Delivery height too great.
C
omply with specifications (8m max. head)
Pressure line diameter too small.
Use pressure line with larger diameter.
Pressure line blocked.
Rectify blockage.
Suction openings blocked.
Clean suction opening.
Pressure line kinked.
Straighten pressure line.
Pressure line leaks.
Seal pressure line, tighten threaded connections
Pump runs very loudly.
Pump draws in air.
E
nsure there is sufficient liquid present.
Keep the pump at an angle while submerging.
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT:
No liability is accepted for incorrect use of this product.
WARRANTY:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
Sole UK Distributor, Sealey Group.
K
empson Way, Suffolk Business Park,
B
ury St. Edmunds, Suffolk.
IP32 7AR
www.sealey.co.uk
01284 757500
01284 703534
Web
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
WEEE Regulations
Dispose of this product at the end of its working life in compliance with the EU Directive on
Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed
of in an environmentally protective way. Contact your local solid waste authority for recycling information.
Parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email [email protected] or telephone 01284 757500.
WPD415| Issue 1 15/12/15
Original Language Version
© Jack Sealey Limited
