Fig.5
3.1.2.
Using a 24mm spanner, turn the nut clockwise. The extractor
will start to extract the bush through the housing (Fig.2).
3.1.3.
Keep turning until the bush has been extracted all the way out
of the housing. Take care as the bush and assembly will fall
away when the bush is fully removed.
NOTE!
If any undue resistance is felt, remove the assembly and check
everything is correctly aligned. The bush will only push out in one
direction.
3.2.
Installing new bush.
3.2.1.
Before installing a new bush, clean the inside of the housing.
3.2.2.
Assemble the installation (gold) set on the housing as in
Fig.4 - viewed from below, and Fig.5. Adaptor (D) is threaded
onto the short threaded end of the bolt (F) with the ridged side
facing inwards. Pass the bolt through the housing from the
rear and then through the bush and then position the Adaptor
(C) over the bolt, fitting it against the bush.
To facilitate correct positioning of the bush, the installation
adaptor (C) has 2 recesses that align with the face of the new
bush (Fig.3). The bush should then be aligned in the housing so
that the rubber locator on the bush is facing directly downwards
(Fig.4). Thread the nut (E) onto the bolt and wind it up to the
adaptor. Double check to make sure that everything is aligned
and that the bush is sitting squarely against the housing.
3.2.3.
Using a 24mm spanner, turn the nut clockwise. The bush will
start to be pushed into the housing.
NOTE!
If any undue resistance is felt, remove the assembly and
check that everything is correctly aligned.
3.2.4.
Continue to turn the nut to install the bush, when the bush
reaches the housing, resistance will be felt and the bush is fully
installed (Fig.6).
3.2.5.
Disassemble the tool, clean and lubricate before returning the
parts to the storage case.
3.2.6.
Re-fit the wish-bone as per
the vehicle manufacturer’s
service instructions or a proprietary manual.
Fig.2
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT:
No liability is accepted for incorrect use of this product.
WARRANTY:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION:
For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park
,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
VSE4781 Issue: 2 - 23/08/11
01284 757500
01284 703534
www.sealey.co.uk
Web
Fig.4
Line up the rubber locator on the new
bush with the bottom of the housing
Fig.3
Position locator on new bush into recess in installation adaptor.
Ridge on new bush fits into groove in adaptor
Fig.6
Parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email [email protected] or phone 01284 757500.