4) If you do wish to proceed to erase the codes, then press the
Y
button.
5) If the codes are cleared successfully, an “
ERASE DONE!
”
confirmation will show on the display. Press any button to return
to previous menus.
6) If the codes are not cleared, then an “
ERASE FAILURE!
”
message will appear. Press the
N
button to return to previous
menus.
3.3 Oil Service
1) Turn the ignition off.
2) Locate the vehicle’s 16-pin Data Link Connector (DLC).
3) Plug the OBDII connector to the vehicle’s DLC.
4) Turn the ignition on. But do not start the engine.
5) Press the
Y
button. The
Main Menu
will be observed on the
display.
6) Use
UP/DOWN
scroll button to select
Oil Service
from the menu,
and press the
Y
button.
Main Menu
1) VW/AUDI
2) OBDII/EOBD
►
3) Oil Service
4) System Setup
If the scan tool fails to communicate with the vehicle, a
“LINK ERROR!” message shows up on the display.
Verify that the ignition is ON;
Check if the scan tool’s OBD II connector is securely
connected to the vehicle’s DLC;
Turn the ignition off and wait for about 10 seconds. Turn the
ignition back on.
< V2.6 USB-V1.9 SERIAL SOFTWARE
V
20
< V2.6 USB-V1.9 SERIAL SOFTWARE
20